ZS Multi-Surface Suction Car Mount for the Apple iPhone 5 / 5S (not suitable for the Apple iPhone 5C).
Use directly on the dashboard or apply to the glass of your windshield.
Dedicated clip-in cradle made & designed to hold the iPhone 5 / 5S securely on the mount.
The ZS mount works on most flat surfaces.
Apply directly to dashboards, console areas or windscreens.
NO NEED FOR ADDITIONAL DASH DISCS or FRICTION MOUNTS.
Part of our NEW range of Mobile Phone / Smart Phone mounts with dedicated cradles which will hold to almost any flat surface within your vehicle.
Simply apply directly to a convenient flat area and view your iPhone 5 / 5S within your line of sight or apply to the windscreen in the traditional way for a really FIRM grip to glass.
The ZS Multi-Surface Mount uses a special PU coated 60mm (2.3") suction cup which, although tacky to touch, it is NOT adhesive so it can be remove and re-apply as many times as you like allowing you to adjust its position or transfer it between vehicles.
The PU coated lever release suction cup gives reliable vacuum grip that holds firm to just about any surface within your car.
The sucker requires a minimum flat area of just 70mm (2.75") diameter for a good grip.
This mount will even hold to textured dashboards and console areas.
So versatile, neat enough for small cars and perfect for larger vehicles such as Motor homes, MPVs, Lorry Cabs, Transit Vans.
If your vehicle has a deep dash or steep sloping windscreen, the ZS Multi-surface Mount allows you to bring your mobile phone / smart phone closer to you for easier viewing.
The dedicated Apple iPhone 5 / 5S cradle is bespoke and designed to allow full access to all ports and buttons (remember that this cradle will not accommodate a case or skin).
Arm length approx 60mm (2.3") - low level design, neat and unobtrusive.
How to apply your ZS Multi-Surface Mount.
Select your chosen position, ensure it is clean, dust free.
Remove the protective film from the sucker.
Position the ZS arm pull down the lever to expel the air and create the vacuum.
Give it a wiggle to ensure it's holding firm then insert your phone onto the dedicated iPhone 5 / 5S holder.
Just lift the lever and pull on the release tab to break the vacuum.
The ZS mount can now be removed
NOTE: Please do not just pull the mount off the surface, you WILL damage it.
Washable; Although your car is probably spotless, dust, fluff & grease can build up on the suction cup causing the suction to fail. If this happens simply rinse the sucker under a running tap & leave to air dry.
Not suitable for oiled areas, loose covered dashboards or areas cleaned with wax or grease treatments.
This item is a bespoke cradle and is suitable only for the iPhone 5 / 5S.
This bespoke cradle is not suitable for use with a case or skin.
View the Video below to see how the ZS Multi-surface Mount works.
Note - may not show the holder for your device.
|Fits Apple||Apple iPhone 5S|