Free standard delivery on UK orders over £20

0

Your Bag is Empty

ZS Stick Anywhere Multi Surface Suction Car Dashboard Mount for the TOMTOM GO 630, 630T & 630HDT (SKU 10265)

SKU: 10265

ZS Multi Surface Suction Car Dashboard Mount for the TOMTOM GO 630, GO 630T & GO 630HDT Traffic (SKU 10265)

SKU: 10265

ZS Multi Surface Suction Car Mount for the TOMTOM GO 630, GO 630T & GO 630HDT.
This low level suction car mount has a PU coated suction cup which will grip to most flat surfaces within your vehicle.
NO NEED FOR ADDITIONAL DISCS OR PADS. Use the ZS Multi Surface arm directly on the dashboard, console or window.

How does it work?
The ZS Multi Surface Mount uses a special PU coated 60mm suction cup which, although tacky to touch, is NOT adhesive so it can be remove and re-applied - Great for multi vehicle drivers.
The PU sucker is on a lever release arm which ensures a reliable vacuum grip.
This sucker only requires a minimum flat area of just 70mm diameter to use.

So versatile, neat enough for small cars and perfect for larger vehicles such as Motorhomes, MPVs, Lorry Cabs, Transit Vans.

If your vehicle has a deep dash or steep sloping windscreen, the ZS Multisurface Mount allows you to bring your satnav closer to you for easier viewing.
Tilt & swivel adjustment to avoid glare.
Arm length approx 60mm - low level design, neat and unobtrusive.

How to apply your ZS Multi Surface Mount.
Select your chosen position, ensure it is clean, dust free.
Remove the protective film from the sucker.
Position the ZS arm pull down the lever to expel the air and create the vacuum.
Give it a wiggle to ensure it's holding firm then insert your TomTom.
To remove;Just lift the lever and pull on the release tab to break the vacuum. The mount can now be lifted away.
NOTE: Remember to pull the lever up and release the vacuum before removing. Tugging the arm will result in damage.

Washable; Although your car is probably spotless, dust, fluff & grease can build up on the suction cup causing the suction to fail. If this happens simply rinse the sucker under a running tap & leave to air dry. Once the PU has reactivated (becomes tacky again) it's ready to use.

Not suitable for oiled areas, loose covered dashboards or areas cleaned with wax or grease treatments.

View the Video below to see how the ZS Multi-surface Mount works.
Note - may not show the holder for your device.

BuyBits Multi Surface Mount - YouTube

Video will open in a new window